POLECAT PAINTBALL'SPOLECAT PAINTBALL'S
BODY PARTS
This page is dedicated to all the miscellaneous parts that attach directly to the Spyder body. Such as Vertical Adapters, Velocity Adjusters, Backcocking Mods and Low Pressure Chambers.
| Low Pressure Chamber For "Standard" Variants | |||||
| Polecat's Home Grown Chamber | $40.00 | ||||
| This and the AKA are the only low pressure chambers that will fit the Polecat Straight Feed. (not pictured) | |||||
| AKA | $40.00 |  |
|||
| ShockTech Black (not pictured) | $24.00 | ||||
| ShockTech Chrome (not pictured) | $28.00 | ||||
| ProLine | $25.00 |  |
|||
| ACI (not pictured) | |||||
| Diamond Labs (not pictured) | $15.00 | ||||
| Bob Long | $30.00 |  |
|||
| Low Pressure Chamber For "Compact" Variants | |||||
| Compact variants come with either one screw on the bottom to hold on the vertical or two screws, one on either side. | |||||
| Bob Long | |||||
| Can be used ONLY on the "one" screw version and comes with an LP chamber. | |||||
| AKA | $47.00 | ||||
| Available in both "one" and "two" screw versions. Does NOT have a built in vertical adapter. | |||||
| Polecat - AKA | $55.00 | ||||
| This is an AKA unit made to fit the Straight Feed conversion and the only one that will. | |||||
| Backcocking Mods | |||||
| Diamond Labs | $21.00 |  |
|||
| The most unique feature is that the guard can be turned either vertical or horizontal. | |||||
| AKA (Not pictured) | $30.00 | ||||
| The AKA is virtually identical to the Diamond Labs. The AKA however, is better made and has AKALMP screened on it. The AKA can only be installed in the vertical as shown. | |||||
| Shark Rails | |||||
| DYE | |||||
| ANS | $23.00 | ||||
| Kingman's TL | |||||
| A customer of mine named this the Rail/Tail. | |||||
| Velocity Adjusters | |||||
| Diamond Labs | $15.00 |  |
|||
| This is a well made adjuster that uses an O-ring (like stock) to dampen movement. The finish isn't the best but it does work well. | |||||
| TASO | $16.00 |  |
|||
| The TASO has a good finish but has a lot of slop in it. I'd much rather have the Diamond Labs on my gun. (Oh yeah, I do!) | |||||
| National |  |
||||
| Vertical Adapters | |||||
| Smart Parts | $25.00 |  |
|||
| The picture might not look like you can screw an ASA into the bottom of this adapter. Yes you can! The extra hole you see in the side is a place to install a gauge. Unfortunately, they no longer come with a gauge port. One can be installed for a nominal fee. | |||||
| Stainless Steel | $20.00 |  |
|||
| These do NOT have the pin to needed to use a tank. They are good for regulators and expansion chambers. | |||||
Suggestions? Comments? Stock checks? E-mail ferret@polecatpaintball.com or (408) 781-1033